FMP Moodboard

Wire Process

I worked with thin bits of wire to construct an lizard. I fist crafted the head of the lizard. I started with a sphere as the base of the head and then added the features to it like the eyes and the mouth area. I then went on to making the body I did that by making a spin for the lizard and connected it to the head from then I made two wire circles  and stuck them on the spine where I would think the legs of the lizard would be. I then made the legs but also connected then to the spine and circles to made the legs bend I had then added some wire to the front legs circle to the head to form a neck kind of look. then after I made the tail and then connected it to the spine. I also places an wire from the back and front wire to make a belly for the lizard. I was happy with it and also enjoyed the stop motion animation I made with it as I would like to do stop motion at some later date.

Plaster Process

Before we could add the plaster to the clay tiles we made, we had to roll out more clay to craft walls for the clay tiles so the plaster wont leak from the clay tiles and make a mess. I rolled my walls out at a good length and then measured them up to the clay tiles to see if I had some clay left over to make another wall. After I put the walls around the tile I had to join up the walls then check the bottom to see if the plaster would not leak. After all that was done we had to make the plaster we did this by using a plaster powder and adding water to it, we would have to keep steering it to mix the powder with the water and after some steering the plasters was ready to pore into the clay tile. When the plaster dried we then got are plaster tiles and I was happy with the design it created with both my tiles

Museum Photos